#Huawei e303 firmware update failed serial
#Huawei e303 firmware update failed software

Megafon or not, as I have seen others listed (but have not bought) with that I am not sure if the -153 is specific only to Other companies mayДistribute this same hardware version under other names, and will usually be The same hardware is sold as a 'stick' model andДЄ 'hilink' model - please see the comments above. The Huawei E3372h-153 device is a 4G LTE USB modem that works with with all Latest versions of usb_modeswitch are able to deal with this: Not recognize it, and does not properly put the device into hilink mode. Occassionally when a hilink device is plugged in, the Linux kernel/udev does This can be done by using this API or by using the usb_modeswitch command Number of standard /dev/ttyUSB* that can then be used to send AT commands.

Note that a hilink device can be put into 'debug' mode which then exposes a Provides standard DHCP and is configured to issue addresses in the range of

#Huawei e303 firmware update failed software

The 'hilink' firmware instead provides a standard USBД®thernet device, with its own subnett'd network and exposes a web interface forД¬ontrolling the software over the ethernet device. These also have a standard tty interface that one can access andД¬ontrol the internals.

#Huawei e303 firmware update failed serial

The primary difference between 'stick' and 'hilink' firmware, is that the stickДЇirmware exposes standard serial ports to the host that work as standard Work, have reported significantly lower than 4G speeds. Additionally, those who have reported getting the stick firmware to Starts with '22.' While some people have had success with getting the stickДЇirmware to work properly with Linux, I personally have not been successfulДoing that. Huawei modems on the market can be updated to a Hilink version of the firmware.ДЇor reference, all 'stick' firmware starts with '21.' and all hilink firmware Rudimentary investigation leads me to believe that the vast majority of the 'hilink' firmware versions, however as I only have one hardware revisionДЄvailable to me, I cannot definitely say which can or cannot be flashed. These devices can sometimes be flashed with the newer Huawei modems with older firmware (circa 2014 and older) are commonly referred Using the wrong firmware will likely brick your device. Should also work for other Huawei devices, but make sure you are using theД¬orrect firmware for your device! Incorrectly flashing your Hilink device, or Posterity to record my notes on installing modified firmware here. Information on Huawei Stick and Hilink devicesД«ecause the documentation available for the E3372h-153 is so poor, especiallyДЇor the version that I have (M150-2, identified by the 'HardwareVersion' ofД¬L2E3372HM), and very little is available in English, I have decided for

Pull requests are greatly appreciated, and encouraged! Hilink API Resources Available Online That said, it should be fairly easy to write a new API call by following Test with and because I have not attempted to do an exhaustive list of all APIД¬alls. This API is currently incomplete, as I only have one type of Hilink device to Package hilink is a Go package for working with Huawei Hilink devices (ie,ДЈG/4G modems and WiFi access devices).

Add information about flashing devices on mac/linux based computers.

Create methods for TTL and IMEI modifications.

Perform some tests with other Huawei devices models.

Add new API calls and methods for latest firmware/WebUI versions.